NYSTEIN Thermal Gel Flextein® TG892S
SKU: FLEXTEIN-TG892S
Syringe-packaged 12.0 W/m·K gel with excellent board adhesion and high extrusion rate for precise, high-volume dispensing.
Key Features
- Thermal conductivity 12.0 W/m · K
- High extrusion rate, good board adhesion
- High weather resistance and reliability
- Easy to dispense, good malleability
Response within 24 hours
Technical Data
Typical Properties
All values are typical and for reference only.| Property | Unit | Value | Test Method |
|---|---|---|---|
| Appearance | Grey | Visual | |
| Extrusion rate | g/min | 25 | Nystein |
| Thermal Conductivity | W/m · K | 12.0 | ISO 22007-2 |
| Density | g/cm³ | 3.35 | ASTM D792 |
| Thermal Resistance | @50 psi °C·in²/W | 0.027 | ASTM D5470 |
| Dielectric Strength | kV/mm | ≥6.0 | ASTM D149 |
| Volume Resistivity | Ω·cm | ≥ 1.0 × 10¹² | ASTM D257 |
| Dielectric Constant | @1MHz | 5 | ASTM D150 |
| Oil Bleeding Rate | % | < 1.0 | 125℃&48h |
| Service Temp | °C | -40 to 150 | Nystein |
| Flame Rating | V-0 | 94 UL | |
| RoHS | Yes | Nystein |
Specifications are subject to change without notice.
Download TDS
Overview
Product Introduction
Flextein TG892S is a high-performance fluidic thermally conductive interface material for heat dissipation modules or components with a wide range of thicknesses. It has good wettability at the interface with metals, so that the mating parts are in full contact and the heat transfer efficiency is improved. It does not need to be die-cut and can be directly dispensed between the heat-generating device and the heat sink/housing, which can replace the thermal conductive gasket to improve thermal conductivity and reduce the cost. Unlike thermally conductive silicone grease, Flextein TG892S thermally conductive gel is non-settling and non-flowing, and is suitable for dispensing equipment.
Use Cases
Applications
Options
Configuration
01
30cc, 55cc, 300cc Syringe.
02
1kg, 10kg pail
Handling
Storage
Sealed at room temperature away from light, and stored in a dry place.
Best storage conditions: Temperature: 25℃ (±3), Humidity: 50% (±10), can be stored for 12 months.
The materials taken out after opening may be contaminated during use, so please do not mix contaminated products with unopened products. Kleber assumes no responsibility for contaminated products or conditions other than the required storage conditions.
For additional information, please contact your appropriate sales, technical support, or customer service representative promptly.